Page dedicated to write down down suggestions and possible improvements found during the progress, please note that board specific suggestions are found over here as well, to keep the pages clear of suggestions and false interpretation.

General

• Use Power Over Ethernet to supply power to the board
• Use grounding to remove any interference and get a proper ground
• Labeled test pin locations
• Advantage notice of the need of additional components during the tests, like 100k resistors and such
• Optic loop back, allows the received signal to be transmitted usefull for outlining purposes (get visual feedback and such)
• Keep in mind batteries could be used as well, so on to low voltage/current switch off circuit instead of during weird resets and wrong oscillation
• Standard wire scheme, so all connector cables could be used on all purposes, without the risk of frying a board
• Some electronics might be worth to be put into a PIC or some other programmable unit, reducing the amount of SMD solder work.

All boards

• No use of serial connectors but use RJ-45 connectors instead, make easy to make and more easy to connect disconnect

Twister2

• Implement a replaceable fuse to ensure a short wire will not burn the whole board.

TxBoard

• Variable resistors on measure points

RxBoard

• RRSI led should output voltages suitable to use for the led.